User's Manual

Chapter 1 — Using the CN30 Mobile Computer
CN30 Mobile Computer User’s Manual 5
Charging and Installing the Battery
To charge the battery
Either insert the battery into the CN30 AC9 Quad charger or place the
CN30 with battery installed in the AD9 charge dock. For more information
on these accessories, see page ‘Accessories for the CN30’.
The batteries fully charge in approximately 4 hours.
If you do not plan to use the computer for several months, remove the key-
pad module from the console and store it in the shipping box.
To install the battery
Insert the tabs on the bottom of the charged battery into the CN30 56-
Keyboard module and snap the battery into place.
Maximizing Battery Life
There are several things that you can do to prolong the life of your fully
charged battery.
1 Verify that the backlight timeout is set to 15 seconds.
2 Verify that Power Management has an automatic shutoff time of 3
minutes.
Checking the Battery Status
The easiest way to tell the status of your battery is to look at the battery
icon in the status bar of your CN30.
You can also check the battery status by looking at the Battery light on the
front of the CN30 or by using the battery diagnostics screen.
To view the status of this battery, tap Start > Settings > the System tab >
the Power icon > the Power tab to view the current status of both the main
battery and the backup battery. Tap ok to exit this information.
Battery Light
Flashes red on low
battery condition