User's Manual Part 1

2
For Users in the United States and Canada
Place this supplement in your manual.
For 700C-802.11b Configuration
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that can cause undesired operation.
Federal Communications Commission Compliance
FCC Digital Emissions Compliance: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the radio or television receiving antenna.
• Increase the separation between the computer equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the radio or television receiver is
connected.
• Consult the dealer or an experienced radio television technician for help.
Operation Warning: To comply with the FCC’s RF exposure requirements and minimize health
hazards:
• The user shall not touch the antenna of this device when the device is in use.
Changes or modifications not expressly approved by Intermec could void the user’s authority to
operate this equipment.
Industry Canada Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
This device requires a radio license unless it is used totally inside a building. (The user must obtain this license.)
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Cet appareil exige une license radio à moins d’être entièrement installé dans un bâtiment. (L’utilisateur doit obtenir
cette license.)
Agency Approvals
This device is UL Listed.
For ABTM3 (Bluetooth-Compatible Wireless Module by Socket Communications)
Configuration
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
Cet appareil est conforme à la Partie 15 des règlements du FCC et à la norme RSS-210 d’Industrie Canada.