User's Manual

Chapter 3 — Configuring the CK60 Computer
CK60 Series Handheld Computer User’s Manual 85
LEAP (Cisco Lightweight EAP)
LEAP is the Cisco Lightweight version of EAP. See page 65 for information
about EAP.
Use “LEAP” to configure the use of LEAP as an authentication protocol,
select “Open,” “WPA,” “WPA2,” or “Network EAP” as an association
mode, or assign “Network EAP.” Note that this defaults to the Network EAP.
To Enable LEAP with an Open Association
1 Set 8021x Security as “LEAP.”
2 Set Association to “Open.”
3 Skip Encryption as it is automatically set to “WEP.” See page 65 for
more information about WEP.
4 Enter your unique User Name to use this protocol.
5 Select Prompt for password to have the user enter this password each
time to access the protocol, or leave Use following password as selected
to automatically use the protocol without entering a password.