User's Manual

Chapter 3 — Configuring the CK60 Computer
CK60 Series Handheld Computer User’s Manual 63
4 The connection label for the SF51 Scanner appears to the right in the
EasySet application, similar to the following. Scan the label once, then
confirm the blue light on end of the SF51 Scanner starts blinking,
which means it is trying to connect.
When connected, the blue light
assumes a steady blue, then SF51 data gets wedged through the keyboard
interface.
Viewing SF51 Scanner Information from Your CK60 Computer
Note that in the CK60 Computer, the Intermec Settings control panel
applet can display up to seven separate SF51 connections. The following
illustration shows two such connections under the Scanners, Symbologies
option.
In this applet, tap Scanners, Symbologies, then tap (+) to expand the SF51
Scanner connections to view MAC addresses, firmware version numbers,
and whether each scanner is connected to the CK60 Computer. When you
clear (uncheck) Enable scanner port, the SF51 Scanner is disconnected
from the CK60 Computer. Check Enable scanner port again to reconnect.
If you want to rename these connections to descriptions more suitable for
your situation, press the stylus on each SF51 Scanner connection for a pop-
up menu, then select Rename. Enter the new description, then tap ok to
save your entry.
When the SF51 Scanner is connected, configuration changes take effect
immediately. When the SF51 Scanner is not connected, configuration
changes take effect once the SF51 Scanner is reconnected.
SF51 identified by device address
SF51 default name