User's Manual

Chapter 1 — Using the CK60 Handheld Computer
CK60 Handheld Computer with Windows CE User’s Manual 5
To scan a bar code label with the 2D area imager
1 Press I to turn on the CK60 Computer.
2 Point the scanner window at the bar code label and hold the CK60
Computer steady a few inches from the label.
3 Press the Scan button on the keypad or pull the trigger on a handle and
center the red aiming beam over the bar code label.
The aiming beam is smaller when the imager is closer to the bar code and
larger when it is further away.
When the CK60 Computer successfully reads a bar code label, you hear
a high beep and the green Good Read light turns on briefly.
4 Release the Scan button.
Supported Devices
The CK60 Computer should connect the following scanner models: 1551,
1553, 1555; ScanPlus 1800SR, 1800ST, 1800VT; Scan Image 1470; SR1
and SG1, SF51. There are a number of different scan engines covered by
these models, including RFID and XLR scan engines. Model 1555 and
Scan Image 1470 are supported as input devices only; configuration of
these models are accomplished by scanning labels.
Using the Ambient Light Sensor
The ambient light sensor automatically turns off the display lighting as sur-
rounding light increases to conserve your CK60 Computer battery power.
As configured from the factory, the ambient light sensor is disabled. To
enable the ambient light sensor and change its settings, tap Start > Settings
> Control Panel. Double-tap the Backlight icon, then tap the right arrow
to scroll to and tap the Both Power tab. Make your selections, then tap OK
to exit this applet.
This assumes the backlight setting once the CK60
Computer is powered on.
This turns off the ambient light sensor.
With this, the backlight is disabled in normal environments.
With this, the backlight is disabled in bright environments.