User's Manual

Chapter 1 — Using the CK60 Handheld Computer
4 CK60 Handheld Computer with Windows CE User’s Manual
2 Remove the battery pack.
3 Press the reset button (shown in the following illustration).
4 Reinstall the battery pack.
Scanning Bar Codes
Use the scanner to scan and enter bar code data. The type of scanner you
are using and the type of bar code you are decoding determines the way you
scan the bar code. The CK60 Computer supports the scanning of 2D
images. Plus, if you are using an integrated handle or a tethered scanner, the
way you scan bar codes is different.
When you unpack the CK60 Computer, these bar code symbologies are
enabled:
•Code39
•UPC/EAN
• PDF417 (if supported)
If you are using bar code labels that are encoded in a different symbology,
you need to enable the symbology on the computer.
Scanning with the 2D Area Imager
The CK60 Computer has the 2D area imager, which provides the ability to
scan 2D bar code symbologies and supports omni-directional (360°) scan-
ning where you can position the CK60 Computer in any orientation to
scan a bar code label. Using the 2D area imager is very similar to taking a
picture with a digital camera.
Do not look directly into the window area or at a reflection of the laser
beam while the laser is scanning. Long-term exposure to the laser beam
can damage your vision.
Avertissement: Ne regardez pas directement la réflexion d’un rayon
laser ou dans la fenêtre du laser lorsque celui-ci est en opération. Si
vous regardez trop longtemps un rayon laser, cela peut endommager
votre vue.
Press this reset button with your stylus.
Do not use force or a sharp object
when pressing the reset button. You
may damage the reset button.