User's Manual

Windows Device Configurations—Chapter 4
67CV60 Vehicle-Mount Computer User's Manual
Note: To enable the touchscreen in units with Windows CE, set COM3 to
Enabled" within the PhoenixBIOS Setup Utility. In units with Windows
XP and Windows XP Embedded, set COM3 to OS Controlled." See
Chapter 3, PhoenixBIOS Setup Utility" for more information.
Stylus
When the CV60 Vehicle-Mount Computer is first reimaged to Windows
CE, Windows XP, or Windows XP Embedded or when it is necessary to
recalibrate (or realign) the touchscreen, use the Stylus Control Panel.
Windows CE
The following information pertains to the Windows CE operating system.
DoubleĆTap
Follow the instructions on this page to set the doubleĆtap sensitivity of
your stylus. Tap OK when finished.
Calibration
This applet calibrates the stylus for the CV60, aligning the Windows curĆ
sor and stylus to the same location on the screen. When complete, the calĆ
ibration values are stored permanently until the next time you do a calibraĆ
tion.
Note: In situations where the touchscreen calibration is off base or is not
usable, use the external keyboard to navigate to the calibration screen.
1 From the CV60 desktop, select Start > Settings > Control Panel,
doubleĆtap the Stylus icon to access the Stylus Properties, then tap the
Calibration tab. Tap Recalibrate to begin.