User's Manual

PhoenixBIOS Setup UtilityChapter —3
32 CV60 Vehicle-Mount Computer User's Manual
User
Enter the parameters of the hardĆdisk drive installed at this connection.
Press the up or down arrow keys < ↑↓ > to move the cursor between the
following fields:
S Cylinders: Enter the number of cylinders involved in this capacity,
range is 0 through 65535. Default is 0.
S Heads: Enter the number of heads involved in this capacity, range is 1
through 16. Default is 1.
S Sectors: Enter the number of sectors involved in this capacity, range is 0
through 63. Default is 0.
S MultiĆSector Transfers: Press the plus (+) or minus (-) key to select beĆ
tween 2, 4, 8, or 16 sectors per block for multiple sector transfers or to
disable the transfer. Default is disabled.
S LBA Mode Control: Press the plus (+) or minus (-) key to enable or
disable the use of the Logical Block Addressing (LBA) in place of cylinĆ
ders, heads, and sectors. Default is disabled.
S 32 Bit I/O Press the plus (+) or minus (-) key to enable or disable 32Ćbit
IDE data transfers. Default is disabled.
S Transfer Mode: Press the plus (+) or minus (-) key to select between
seven methods by which to move data to and from the drive. Default is
Standard.
S Ultra DMA Mode: Press the plus (+) or minus (-) key to select between
six ultra DMA modes by which to move data to and from the drive or
to disable the movement. Default is Disabled.
Secondary Master
Press [Enter] to access the Secondary Master menu. Press [Esc] to return
to the Main menu.
At the Type field, press the plus (+) or minus (-) key to change the value to
one of the following. The value selected dictates what configurable inforĆ
mation is presented. Default is SanDisk SDP3B-85.
Auto
Select this to automatically set the hardĆdisk drive installed. Press the up or
down arrow keys < ↑↓ > to move the cursor to the following field:
S 32 Bit I/O: Press the plus (+) or minus (-) key to enable or disable
32Ćbit IDE data transfers. Default is disabled.
None
Select this if there is no hardĆdisk drive.
CDĆROM
This indicates that a CDĆROM drive is the drive installed. Press the up or
down arrow keys < ↑↓ > to move the cursor between the following fields:
S MultiĆSector Transfers: Press the plus (+) or minus (-) key to select beĆ
tween 2, 4, 8, or 16 sectors per block for multiple sector transfers or to
disable the transfer. Default is disabled.