User's Manual

PhoenixBIOS Setup Utility—Chapter 3
31CV60 Vehicle-Mount Computer User's Manual
S Transfer Mode: Press the plus (+) or minus (-) key to select between
seven methods by which to move data to and from the drive. Default is
Standard.
S Ultra DMA Mode: Press the plus (+) or minus (-) key to select between
six ultra DMA modes by which to move data to and from the drive or
to disable the movement. Default is Disabled.
ATAPI Removable
This indicates the removable disk drive is installed in the ATAPI sector.
Press the up or down arrow keys < ↑↓ > to move the cursor between the
following fields:
S MultiĆSector Transfers: Press the plus (+) or minus (-) key to select beĆ
tween 2, 4, 8, or 16 sectors per block for multiple sector transfers or to
disable the transfer. Default is disabled.
S LBA Mode Control: Press the plus (+) or minus (-) key to enable or
disable the use of the Logical Block Addressing (LBA) in place of cylinĆ
ders, heads, and sectors. Default is disabled.
S 32 Bit I/O Press the plus (+) or minus (-) key to enable or disable 32Ćbit
IDE data transfers. Default is disabled.
S Transfer Mode: Press the plus (+) or minus (-) key to select between
seven methods by which to move data to and from the drive. Default is
Standard.
S Ultra DMA Mode: Press the plus (+) or minus (-) key to select between
six ultra DMA modes by which to move data to and from the drive or
to disable the movement. Default is Disabled.
Other ATAPI
This indicates the disk drive is installed in an ATAPI sector other than the
removable sector. Press the up or down arrow keys < ↑↓ > to move the
cursor between the following fields:
S MultiĆSector Transfers: Press the plus (+) or minus (-) key to select beĆ
tween 2, 4, 8, or 16 sectors per block for multiple sector transfers or to
disable the transfer. Default is disabled.
S LBA Mode Control: Press the plus (+) or minus (-) key to enable or
disable the use of the Logical Block Addressing (LBA) in place of cylinĆ
ders, heads, and sectors. Default is disabled.
S 32 Bit I/O Press the plus (+) or minus (-) key to enable or disable 32Ćbit
IDE data transfers. Default is disabled.
S Transfer Mode: Press the plus (+) or minus (-) key to select between
seven methods by which to move data to and from the drive. Default is
Standard.
S Ultra DMA Mode: Press the plus (+) or minus (-) key to select between
six ultra DMA modes by which to move data to and from the drive or
to disable the movement. Default is Disabled.