User's Manual

OperationChapter —2
16 CV60 Vehicle-Mount Computer User's Manual
Startup Requirements
Before powering up the computer for the first time, be sure it is securely
mounted, that all cable connections are secure, and that the DC power inĆ
put cable is firmly attached.
The computer begins its boot (start up) sequence when power is supplied
to the DC power input connector and the On/Off switch is ON (press the
switch briefly).
In the case of an AC-powered (fixed-mount) computer, the power supply
must be connected to the computer and plugged into a wall outlet.
Vehicle mounts require that the DC-DC power converter be properly conĆ
nected to the vehicle batteries and to the computer.
CV60 Vehicle-Mount Computer
Startup Sequence
Your computer should start up after all connections have been made, power
has been applied, and the On/Off switch has been pressed.
During startup, the computer (1) performs a power-on self-test, (2) runs
the hardware initialization program, and (3) boots the operating system.
Once the computer boots" (starts up) successfully, you may load additionĆ
al application software if this has not already been done for you. If you
install a radio or other optional device, you may have to install driver softĆ
ware or make new system setups for the device(s) to work properly.