User's Manual

Pocket PC 2002Chapter —2
72 700 Series Color Mobile Computer User’s Manual
4 The first time you insert the card, Network Settings will appear
automatically so that you can configure the Ethernet card. Most
networks use DHCP, so you should not have to change these settings
unless your network administrator instructs you to do so. Tap OK.(Ifit
does not appear or to change settings later, tap Start → Settings → the
Connections tab → Network, tap the adapter you want to change, and
then tap Properties.)
S If using an on-board Ethernet, then select Start → Settings → the
Connections tab → Network Adapters. Select “NE2000 Compatible
Ethernet Driver” from the list of adapters installed, then tap Proper-
ties to configure the Ethernet driver.
5 Connect the Ethernet card or dock to the network by using a network
cable. For information, see your owner’ s manual.
6 To synchronize your 700 Series Computer, tap Start → ActiveSync.In
the Tools menu, tap Options. → the PC tab, select Include PC when
synchronizing remotely and connect to, and select your computer’ s
name. Remote synchronization with a desktop computer will work only
if a partnership is set up with that computer through ActiveSync and
ActiveSync is set to allow remote connections. Other restrictions apply.
For more information, see ActiveSync Help on the desktop computer.
To start the connection, simply start using one of the programs listed in
the preceding section. Once connected, you can perform the same activi-
ties as listed in the preceding section.
Ending a Connection
To disconnect, do one of the following:
S When connected via dial-up or VPN, tap the Connection icon (shown
left) on your navigation bar, and then tap End.
S When connected via cable or cradle, detach your 700 Series Computer
from the cable or cradle.
S When connected via Infrared, move the 700 Series Computer away
from the PC.
S When connected via a network (Ethernet) card, remove the card from
your 700 Series Computer.
Connecting Directly to an E-mail Server
You can set up a connection to an e-mail server so that you can send and
receive e-mail messages by using a modem or network connection and In-
box on your 700 Series Computer.
Note: The ISP or network must use a POP3 or IMAP4 e-mail server and
an SMTP gateway.
You can use multiple e-mail services to receive your messages. For each e-
mail service you intend to use, first set up and name the e-mail service. If
you use the same service to connect to different mailboxes, set up and
name each mailbox connection.