User's Manual

Pocket PC 2002Chapter —2
70 700 Series Color Mobile Computer User’s Manual
5 Connect the Ethernet card or dock to the network by using a network
cable. For information, see your owner’ s manual.
6 Tap Start → Settings → the Connections tab → Connections.From
the My network card connects to list, select “Internet.”
To start the connection, simply start using one of the programs listed in
the preceding section. Once connected, you can perform the same activi-
ties as listed in the preceding section.
Connecting to Work
If you have access to a network at work, you can send e-mail messages,
view intranet pages, synchronize your 700 Series Computer, and possibly
access the Internet. You can connect to work in one of two ways:
S Create a modem connection by using a RAS (Remote Access Server) ac -
count. Before you can create this modem connection, your network ad-
ministrator will need to set up a RAS account for you. If this is the
method you want to use, see “Creating a Modem Connection to Work”
below. Your network administrator may also give you VPN settings.
S Use an Ethernet card and a net tap to connect to the network. If this is
the method you want to use, see “Creating an Et hernet Connection to
Work” on page 71.
Creating a Modem Connection to Work
1 Get the following information from your network administrator:
S Dial-up access telephone number
S User name
S Password
S Domain name
S TCP/IP settings
2 If your 700 Series Computer does not have a built-in modem, install a
modem card.
3 Tap Start → Settings → the Connections tab → Connections.Under
The Internet settings, select Internet Settings and tap Modify.
4 In the Modem tab, tap New.
5 Enter a name for the connection, such as “Company Connection.”
6 In the Select a modem list, select your modem type. If your modem
type does not appear, try reinserting the modem card. If you are using
an external modem that is connected to your 700 Series Computer with
a cable, select “Hayes Compatible on COM1.”
7 You should not need to change any settings in Advanced. Most servers
now use a dynamically-assigned address. If the server you are connecting
to does not use a dynamically-assigned address, tap Advanced
→
the
TCP/IP tab and then enter the address. When finished, tap OK
→
Next.