User's Manual

Chapter 2 — Windows Mobile Version 5.0
CN30 Mobile Computer User’s Manual 51
• b In the Area code box, enter the area code. Area codes are not needed in
all countries.
• c Enter the main phone number, then tap Next to continue.
4Enter the user name, password, and domain (if provided by an ISP or
your network administrator). Ifa domain name was not provided, try the
connection without entering a domain name.
5You should not need to change any advanced settings. Instances where
you are to change advanced settings include the following. To change
advanced settings, tap Advanced.Otherwise,tap Finish.
• You want to change baudrate settings, dialing string commands, or credit
card options.
• You need to change port settings.
• The server you are connecting to does not use dynamically-assigned
addresses, and you need to enter your TCP/IP settings.
Note: The following information applies when you have “Wireless 802.11”
selected via the NDISTRAY pop-up menu.
Creating aWireless NetworkConnection
Microsoft Corporation’s wireless network configuration tool is called
“Wireless Zero Config.” Intermec Technologies recommends that you use
the Wireless Network control panel applet instead as itoffers more security
choices and exhibit better roaming behavior. Information about the Wire-
less Network control panel applet is in Appendix A.
Networks already configured are preferred networks and are listed in Wire-
less networks. You can connect to only preferred networks or search for and
connect to any available network.
A wireless network can be added either when the network is detected, or
manually by entering settings information. To determine if authentication
information is needed, see your network administrator.
2Tap the Advanced tab > Network Card >the Wireless tab > Add New ... .
3Tap the General tab, then enter a network name. If the network was
detected, the network name is entered and cannot be changed.
From Connects to, select to what your network is to connect. If you select
“Work,” you can do a vpn connection or use proxy servers. If you select
“The Internet,” you can connect directly to the internet.
To connect to an ad-hoc connection, select This is a device-to-device (ad-
hoc) connection.
4Tap the Network Key tab, then do the following:
To DisableAuthentication
aSet Authentication to either “Open” if WEP keys are notrequired;