User's Manual
Table Of Contents
- Before You Begin
- Safety Icons
- Global Services and Support
- Chapter 1 Using the CN30 Mobile Computer
- Audio
- Using the Battery
- Charging and Installing the Battery
- Beeper
- Select a Beeper Volume
- Using the Keypad
- Using the Power (I) Key
- Using the Screen
- Resetting Your CN30 Mobile Computer
- Software Build Version
- Chapter 2 Windows Mobile Version 5.0
- To Check the Intermec Build
- Where to Find Information
- Getting Started
- Programs
- Entering Information
- Selecting the Writing
- Converting Writing to Text
- Customizing Your CN30 Mobile Computer
- Adding Programs Using ActiveSync
- Microsoft ActiveSync
- Adding a Program to the Start Menu
- Microsoft Pocket Outlook
- Tasks: Keeping a To Do List
- Notes: Capturing Thoughts and Ideas
- Chapter 3 Installing Applications
- Installing Applications
- Using Microsoft ActiveSync
- Using a Storage Card
- Migrating from Another Computer
- Chapter 4 Network Support
- Configuring the CN30 With the setup Assistant
- Configuring 802.1X Radio Communications
- Configuring the Network Parameters for a TCP/IP Network
- Configuring Security
- Configuring 802.1X Security
- Loading Certificates
- Configuring a VPN
- SNMP Configuration on the CN30 Mobile Computer
- Chapter 7 Programming
- Creating CAB Files
- Creating CAB Files with the CAB Wizard
- Customization and Lockdown
- Networking APIs
- Basic Connect/Disconnect Functions
- Appendix A Specifications
- Physical and Environmental Specifications
- Hardware
- Power Specifications
- Accessories
Chapter 1 — Using the CN30 Mobile Computer
6 CN30 Mobile Computer User’s Manual
Your computer contains an internal super capacitor, a temporary power
storage device, that protects data for up to ten minutes. This is to give you
time to replace the main battery pack before that data is lost. Be sure to put-
the computer in a suspend mode before doing so.
The configuration and time are lost if:
• The battery discharges beyond this level.
• The battery is removed when the computer is not in suspend mode.
• A cold reset is performed on the computer.
Beeper
For information about setting volume levels for screen taps, ActiveSync
alert noises, etc., tap Start > Help > Learning the Basics
, then select Adjust
the volume for sounds.
Enable the Beeper
To enable the beeper:
1 Tap Start > Settings > the Personal tab > Sounds & Notifications >
the Volume tab.
2 Drag the System volume slider bar to the bottom of the “Silent” posi-
tion.
3 Tap ok to exit this applet.