User's Manual
Table Of Contents
- Before You Begin
- About the Computer Features
- About the User Interface and Intermec Applications
- Use the Phone
- Use the Camera
- Use GPS
- Configure the Computer
- How to Configure the Computer
- About Intermec Settings on the Computer
- Configure the Computer Remotely with SmartSystems
- About Network Communications
- About Wireless Security
- Load a Certificate
- How to Make Your Security Choice
- Select a Funk Security Profile
- Configure WPA or WPA2 Enterprise (802.1x) Security with Funk Security
- Configure WPA or WPA2 Personal (PSK) Security with Funk Security
- Configure 802.1x Security with Funk Security
- Configure LEAP Security with Funk Security
- Configure Static WEP Security with Funk Security
- Use Open (No Security) Associations with Funk Security
- Select Microsoft as Your Security Choice
- Configure WPA or WPA2 Enterprise (802.1x) Security with Microsoft Security
- Configure WPA or WPA2 Personal (PSK) Security with Microsoft Security
- Configure 802.1x Security with Microsoft Security
- Configure Static WEP Security with Microsoft Security
- Use Open (No Security) Associations with Microsoft Security
- Manage the Computer
- Troubleshoot and Maintain the Computer
- Specifications
- Keypads and Keystrokes
Chapter 4 — Use the Camera
66 Document Title
Note: To perform document capture using the camera, you must use Intermec
Settings to configure all document capture settings.
Enable or Disable Document Capture With the Camera
You use the Profile Settings application to enable or disable document
capture with the camera. Performing document capture with the
camera is disabled by default.
1 Tap Start > ProfileSettings.
2 Tap Camera.
3 In the Camera menu, tap Enable document image to enble
document capture.
To disable document capture, tap Disable bar code scan.
4 Tap OK.
Perform Document Capture With the Camera
After you enable document capture with the camera, document
capture images are saved to the MyDocuments\MDI directory on the
computer by default.
1 Place your document on a flat surface.
2 Position the computer a few inches above the center of the
document.
3 Press and hold the Scan button. The video preview and camera
viewfinder frame appear.
<ILLUSTRATION?>
When the viewfinder tries to detect the document edges, the
viewfinder frame is red and pulses slightly.
4 Move the camera to align the document edges with the viewfinder.
When the viewfinder detects the document edges, the viewfinder
Note: You can also enable document capture by setting parameters in
Intermec Settings.
DRAFT