User's Manual
Table Of Contents
- Before You Begin
- About the Computer Features
- About the User Interface and Intermec Applications
- Use the Phone
- Use the Camera
- Use GPS
- Configure the Computer
- How to Configure the Computer
- About Intermec Settings on the Computer
- Configure the Computer Remotely with SmartSystems
- About Network Communications
- About Wireless Security
- Load a Certificate
- How to Make Your Security Choice
- Select a Funk Security Profile
- Configure WPA or WPA2 Enterprise (802.1x) Security with Funk Security
- Configure WPA or WPA2 Personal (PSK) Security with Funk Security
- Configure 802.1x Security with Funk Security
- Configure LEAP Security with Funk Security
- Configure Static WEP Security with Funk Security
- Use Open (No Security) Associations with Funk Security
- Select Microsoft as Your Security Choice
- Configure WPA or WPA2 Enterprise (802.1x) Security with Microsoft Security
- Configure WPA or WPA2 Personal (PSK) Security with Microsoft Security
- Configure 802.1x Security with Microsoft Security
- Configure Static WEP Security with Microsoft Security
- Use Open (No Security) Associations with Microsoft Security
- Manage the Computer
- Troubleshoot and Maintain the Computer
- Specifications
- Keypads and Keystrokes
Chapter 4 — Use the Camera
Document Title 63
2 Position the computer about 20 cm (8 in) over the bar code you
want to read. Make sure nothing is blocking the camera lens.
3 Press and hold the Scan button. The screen turns into a viewfinder
with an aiming bar across the middle of the screen.
4 Center the aiming bar over the bar code and release the Scan
button. The bar code is read and the data appears in the active
application.
If the computer does not read the bar code right away, release the
Scan button and try again. You may need to move the computer
closer to or further away from the bar code for best results.
Camera Settings for Reading Bar Codes
To use the camera for reading bar codes, you must use the Intermec
Settings application to configure the camera. From the main screen of
Intermec Settings, select Data Collection > Camera > Camera
Settings.
Optimized Imager Mode (Advanced) Settings and Descriptions
Setting Description Choices
Imager decode
mode
• Linear imager
emulation
• 2D imager
Lighting mode
• Illumination
LED priority
• Aperture priority
Lighting goal Default is 30.
Illumination level Default is 3.
Initial 1D search
area
• Center
• Full
• Smart raster
Damaged 1D codes
• Disable
• Enable
DRAFT