User's Manual
Table Of Contents
- Before You Begin
- About the Computer Features
- About the User Interface and Intermec Applications
- Use the Phone
- Use the Camera
- Use GPS
- Configure the Computer
- How to Configure the Computer
- About Intermec Settings on the Computer
- Configure the Computer Remotely with SmartSystems
- About Network Communications
- About Wireless Security
- Load a Certificate
- How to Make Your Security Choice
- Select a Funk Security Profile
- Configure WPA or WPA2 Enterprise (802.1x) Security with Funk Security
- Configure WPA or WPA2 Personal (PSK) Security with Funk Security
- Configure 802.1x Security with Funk Security
- Configure LEAP Security with Funk Security
- Configure Static WEP Security with Funk Security
- Use Open (No Security) Associations with Funk Security
- Select Microsoft as Your Security Choice
- Configure WPA or WPA2 Enterprise (802.1x) Security with Microsoft Security
- Configure WPA or WPA2 Personal (PSK) Security with Microsoft Security
- Configure 802.1x Security with Microsoft Security
- Configure Static WEP Security with Microsoft Security
- Use Open (No Security) Associations with Microsoft Security
- Manage the Computer
- Troubleshoot and Maintain the Computer
- Specifications
- Keypads and Keystrokes
Chapter 4 — Use the Camera
62 Document Title
How To Read Bar Codes With the Camera
You can use the camera to read bar codes. When you read bar codes
with the camera, the computer treats the camera as it would any input
device, such as a Bluetooth scanner, and bar code data is sent to an
application as if it came from a scanner or imager.
There are two ways to enable reading bar codes with the camera:
• You can use the Profile Settings application to enable bar code
reading. The computer uses the current symbology decode settings
to read bar code data.
• You can configure individual parameters in Intermec Settings to
enable bar code reading.
Note: To read bar codes using the camera, you must use Intermec Settings to
configure bar code symbology decode settings.
Enable or Disable Reading Bar Codes With the Camera
You use the Profile Settings application to enable or disable reading
bar codes with the camera. Reading bar codes with the camera is
disabled by default.
1 Tap Start > ProfileSettings.
2 Tap Camera.
3 In the Camera menu, tap Enable bar code scan or Disable bar
code scan as necessary.
4 Tap OK.
Read Bar Codes With the Camera
After you enable reading bar codes with the camera, the computer
sends bar code data to applications as keyboard input.
1 Start the application that is to receive the bar code data.
Note: You can also enable reading bar codes by setting parameters in
Intermec Settings.
DRAFT