User's Manual
Table Of Contents
- Before You Begin
- About the Computer Features
- About the User Interface and Intermec Applications
- Use the Phone
- Use the Camera
- Use GPS
- Configure the Computer
- How to Configure the Computer
- About Intermec Settings on the Computer
- Configure the Computer Remotely with SmartSystems
- About Network Communications
- About Wireless Security
- Load a Certificate
- How to Make Your Security Choice
- Select a Funk Security Profile
- Configure WPA or WPA2 Enterprise (802.1x) Security with Funk Security
- Configure WPA or WPA2 Personal (PSK) Security with Funk Security
- Configure 802.1x Security with Funk Security
- Configure LEAP Security with Funk Security
- Configure Static WEP Security with Funk Security
- Use Open (No Security) Associations with Funk Security
- Select Microsoft as Your Security Choice
- Configure WPA or WPA2 Enterprise (802.1x) Security with Microsoft Security
- Configure WPA or WPA2 Personal (PSK) Security with Microsoft Security
- Configure 802.1x Security with Microsoft Security
- Configure Static WEP Security with Microsoft Security
- Use Open (No Security) Associations with Microsoft Security
- Manage the Computer
- Troubleshoot and Maintain the Computer
- Specifications
- Keypads and Keystrokes
Chapter 3 — Use the Phone
Document Title 43
If you plan to add a carrier, you should enable automatic
configuration of carrier settings before you activate the phone for the
new carrier. This feature is disabled by default.
Enable Automatic Configuration of Carrier Settings
If you plan to add another WAN radio network carrier, you should
enable automatic confguration of carrier settings before you activate
the phone for the new carrier.
1 Tap Start > Settings > System > Intermec Settings.
2 Tap Communications > WWAN > Carrier Settings Auto
Config.
3 Select Enabled and tap OK.
Switch Carriers Using Intermec Settings
Use Intermec Settings to quickly change your WAN radio network
carrier.
1 Tap Start > Settings > System > Intermec Settings >
Communications > WWAN > Carrier Choice.
2 Select a Carrier and tap OK.
If the update is successful, your new carrier appears in the WWAN
settings list.
If the update is unsuccessful, the carrier does not change.
3 Tap Ok to exit Intermec Settings.
Note: Your computer must have the software-defined radio to use this
feature.
Note:Your computer must have the software-defined radio to switch
carriers using this method.
DRAFT