User's Manual
Table Of Contents
- Before You Begin
- About the Computer Features
- About the User Interface and Intermec Applications
- Use the Phone
- Use the Camera
- Use GPS
- Configure the Computer
- How to Configure the Computer
- About Intermec Settings on the Computer
- Configure the Computer Remotely with SmartSystems
- About Network Communications
- About Wireless Security
- Load a Certificate
- How to Make Your Security Choice
- Select a Funk Security Profile
- Configure WPA or WPA2 Enterprise (802.1x) Security with Funk Security
- Configure WPA or WPA2 Personal (PSK) Security with Funk Security
- Configure 802.1x Security with Funk Security
- Configure LEAP Security with Funk Security
- Configure Static WEP Security with Funk Security
- Use Open (No Security) Associations with Funk Security
- Select Microsoft as Your Security Choice
- Configure WPA or WPA2 Enterprise (802.1x) Security with Microsoft Security
- Configure WPA or WPA2 Personal (PSK) Security with Microsoft Security
- Configure 802.1x Security with Microsoft Security
- Configure Static WEP Security with Microsoft Security
- Use Open (No Security) Associations with Microsoft Security
- Manage the Computer
- Troubleshoot and Maintain the Computer
- Specifications
- Keypads and Keystrokes
Chapter 1 — About the Computer Features
Document Title 19
For near or close-in scanning distances of 30 cm (11.8 in) or less,
use the laser pointer as a guide and aim slightly to the right of the
center of the bar code. Make sure the illumination beam covers the
bar code you are trying to decode.
For standard and long range scanning distances of 30 cm (11.8 in)
or more, use the laser pointer as a guide and aim toward the middle
of the bar code. Make sure that the illumination beam covers the
bar code you are trying to decode.
When the imager successfully reads a bar code label, you hear a
high beep, and the Good Read LED turns on briefly.
3 Release the Scan button or trigger.
DRAFT