User's Manual

Chapter 6 — Configure the Computer
Document Title 97
4 For Infrastructure Mode, select Infrastructure.
5 For Association, select WPA-PSK or WPA2-PSK.
The default encryption is TKIP or AES, respectively.
6 For Pre-Shared Key, enter the pre-shared key or passphrase:
• Enter the pre-shared key (0x followed by 32 hexadecimal pairs)
for your access point.
• Enter the passphrase (8 to 63 ASCII characters) for your
authenticator. The computer internally converts the passphrase
to a pre-shared key.
7 Tap OK.
Configure 802.1x Security with Microsoft Security
Before you set 802.1x-WEP security with Microsoft security, you need
to enable the radio on your computer and set the date. To use TLS
protocol, you also need to load a user and root certificate. Intermec
recommends that you use WPA2-802.1x instead of 802.1x-WEP if
possible.
1 Start Intermec Settings.
2 Select Communications > 802.11 Radio > Microsoft Security.
3 Enter the Network name (SSID).
4 For Infrastructure Mode, select Infrastructure.
5 For Network Authentication, select Open.
6 For Data Encryption, select WEP.
7 For 802.1X Authentication, select TLS or PEAP.
8 Select Hidden Network.
9 Tap OK. The User Logon dialog box appears.
10 If you selected PEAP:
a Enter a User Name, Password, and Domain.
b If you want to save the password for future authentication
sessions, select Save Password.
DRAFT