User's Manual

1
CV61 Compliance Insert
Model 1011CM01
The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of
accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void
the compliance of this product and may result in the loss of the user’s authority to operate the equipment.
Battery Information
Battery Recycling Information
Note: In the U.S.A., the EPA does not consider spent Li-ion batteries as hazardous waste.
Radiation Exposure Statement
Radio Wave Exposure and Specific Absorption Rate (SAR) Information
Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits
established for this equipment.
When installing and using this product, a 20 cm (or greater distance per MPE calculation) passing distance must be maintained from the body
or head of the user or nearby persons and the antenna. The antenna must not be touched during transmitter operation.
For Users in the United States and Canada
Digital Emissions Compliance
This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standards. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their own expense.
802.11 Radio Precaution Statement
• 802.11a wireless LAN 5150 to 5250 MHz (5.15 to 5.25 GHz) (5 GHZ radio channels 34 to 48) is restricted to indoor operations to reduced
harmful interference to co-channel Mobile Satellite System (MSS) operations.
• The maximum antenna gain permitted for devices in the bands 5250 to 5350 MHz and 5470 to 5725 MHz shall comply with the e.i.r.p.
limit.
• The maximum antenna gain permitted for devices in the band 5725 to 5825 MHz shall comply with the e.i.r.p. limits specified for point-to-
point and non point-to-point operation as appropriate.
• Be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250 to 5350 MHz and 5650 to 5850 MHz
and that these radars could cause interference and/or damage to LE-LAN devices.
Caution: This marking indicates that the user should read all included documentation before use.
Caution: For vehicle applications observe all warnings and cautions contained in installation instructions. Installations involving
vehicle power sources above 60 V should be done by a trained service person to avoid injury or damage to equipment.
Caution: For use with Intermec battery pack Model 1011AB01 only. See battery instructions. For power supply, use Model
9006AE01, 851-070-001, or Model AE10. No user-serviceable parts.
Caution: The batteries used in this device may ignite, create a chemical burn hazard, explode, or release toxic materials if mistreated.
Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from children.
Promply dispose of used batteries according to the instructions.
Li-ionLi-ion
This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent
battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid
waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
,
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,
Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and CENELEC
limits for exposure to radio frequency (RF) radiation.
Caution: Users are responsible for configuring the channels of operation that comply with their country regulatory standards. A
Wireless Network Administrator should review the operating restrictions detailed within the Access Point installation manual.
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel [phone]
fax [phone]
www.intermec.com
© 2012 Intermec Technologies
Corporation. All rights reserved.
CV61 Compliance Insert
*933-283-001*
P/N 933-283-001, Revision A