User's Manual
Table Of Contents
- Using the Data Collection PC
- Safety Information
- About the CV61 Data Collection PC
- Overview of CV61 Features
- About the Ready-to-Work Indicator
- CV61 Accessories
- Mounting the CV61
- Connecting the CV61 to Power
- Installing an SD Card
- 1 Turn off the CV61.
- 2 Remove the power cord.
- 3 Using a small Phillips screwdriver, remove the eight screws that secures the radome cover to the CV61.
- 4 Gently lift up the radome cover to expose the SD card slot.
- 5 Insert the SD card into place.
- 6 Close the radome cover and replace the ten screws.
- 7 Reattach the power cord.
- 8 Press the Power button. The computer turns on.
- Adjusting the Volume
- About the Touch Screen
- Installing an External Antenna
- Attaching an External Keyboard
- Connecting a Tethered Scanner
- 1) Attach the RS-232 cable to one of the COM ports on the CV61.
- 2) Attach the other end of the cable to a tethered scanner.
- 3) Select Start > Control Panel > Intermec Settings.
- 4) Go to Data Collection > Tethered Scanner > Enable Scanner Port.
- 5) Make sure Enable scanner port is checked.
- 6) Tap OK to save your settings.
- 7) Go to Scanner Settings > Scanner model and select your scanner from the list.
- 8) Tap OK to save your settings.
- 9) TapMenu > Exit to exit Intermec Settings.
- 1) Attach the RS-232 cable to one of the COM ports on the CV61.
- Physical and Environmental Specifications
Chapter 1 — Using the Data Collection PC
14 CV61 Data Collection PC User Guide
2 Secure the antenna to the CV61 antenna plug.
3 Using your own hardware, secure the external antenna to a wall,
forklift, or other flat surface.
Attaching an External Keyboard
You can use either a PS/2 or USB keyboard with the CV61. Intermec
recommends you use CV61 rugged keyboard to input text. For more
information on purchasing the Intermec keyboard, contact your local
Intermec representative.