User's Manual
Table Of Contents
- Using the Data Collection PC
- Safety Information
- About the CV61 Data Collection PC
- Overview of CV61 Features
- About the Ready-to-Work Indicator
- CV61 Accessories
- Mounting the CV61
- Connecting the CV61 to Power
- Installing an SD Card
- 1 Turn off the CV61.
- 2 Remove the power cord.
- 3 Using a small Phillips screwdriver, remove the eight screws that secures the radome cover to the CV61.
- 4 Gently lift up the radome cover to expose the SD card slot.
- 5 Insert the SD card into place.
- 6 Close the radome cover and replace the ten screws.
- 7 Reattach the power cord.
- 8 Press the Power button. The computer turns on.
- Adjusting the Volume
- About the Touch Screen
- Installing an External Antenna
- Attaching an External Keyboard
- Connecting a Tethered Scanner
- 1) Attach the RS-232 cable to one of the COM ports on the CV61.
- 2) Attach the other end of the cable to a tethered scanner.
- 3) Select Start > Control Panel > Intermec Settings.
- 4) Go to Data Collection > Tethered Scanner > Enable Scanner Port.
- 5) Make sure Enable scanner port is checked.
- 6) Tap OK to save your settings.
- 7) Go to Scanner Settings > Scanner model and select your scanner from the list.
- 8) Tap OK to save your settings.
- 9) TapMenu > Exit to exit Intermec Settings.
- 1) Attach the RS-232 cable to one of the COM ports on the CV61.
- Physical and Environmental Specifications
Chapter 1 — Using the Data Collection PC
CV61 Data Collection PC User Guide 13
To adjust the screen brightness manually:
1 Tap Start > Control Panel > CV61 Properties.
2 In Brightness Control, make sure that Adaptive Brightness
Control is not selected.
3 Using the slider, adjust the screen brightness.
4 Tap Apply to save your changes.
5 Tap OK to exit the CV61 Properties menu.
Installing an External Antenna
You can purchase an antenna to mount on a wall, forklift, or other flat
surface using either screws or small patches of adhesive-backed hook
and loop fastener material.
Since system performance and antenna polarization are
site-dependent, a permanent mounting location may require some
experimentation. In most fixed installations, you should mount the
antenna initially in a vertically-polarized position, with the cable from
the antenna parallel to the floor and ceiling.
To connect an external antenna:
1 Remove the antenna cover.