User's Manual
Table Of Contents
- Using the Data Collection PC
- Safety Information
- About the CV61 Data Collection PC
- Overview of CV61 Features
- About the Ready-to-Work Indicator
- CV61 Accessories
- Mounting the CV61
- Connecting the CV61 to Power
- Installing an SD Card
- 1 Turn off the CV61.
- 2 Remove the power cord.
- 3 Using a small Phillips screwdriver, remove the eight screws that secures the radome cover to the CV61.
- 4 Gently lift up the radome cover to expose the SD card slot.
- 5 Insert the SD card into place.
- 6 Close the radome cover and replace the ten screws.
- 7 Reattach the power cord.
- 8 Press the Power button. The computer turns on.
- Adjusting the Volume
- About the Touch Screen
- Installing an External Antenna
- Attaching an External Keyboard
- Connecting a Tethered Scanner
- 1) Attach the RS-232 cable to one of the COM ports on the CV61.
- 2) Attach the other end of the cable to a tethered scanner.
- 3) Select Start > Control Panel > Intermec Settings.
- 4) Go to Data Collection > Tethered Scanner > Enable Scanner Port.
- 5) Make sure Enable scanner port is checked.
- 6) Tap OK to save your settings.
- 7) Go to Scanner Settings > Scanner model and select your scanner from the list.
- 8) Tap OK to save your settings.
- 9) TapMenu > Exit to exit Intermec Settings.
- 1) Attach the RS-232 cable to one of the COM ports on the CV61.
- Physical and Environmental Specifications
Chapter 1 — Using the Data Collection PC
CV61 Data Collection PC User Guide 11
If you are going to use the CV61 in extreme cold conditions for an
extended period of time, you should turn on the power at room
temperature for at least 15 minutes prior to using it. This process of
“warming up” helps preserve the lighting on the display.
The default screen appears on the display when you turn on the CV61.
This screen appears unless you are running ITE. If you have installed
ITE, it launches after the initial booting process.
Windows 7 Default Screen on the CV61
Enabling the Heated Display
Use the heated display to help reduce condensation on an external
surface when you are moving between sub-freezing and normal
temperatures.
To enable the heated display
1 Tap Start > Control Panel > CV61 Properties.
Windows 7
Taskbar