User's Manual

Chapter 6 — Configuring the Computer
70 Series Mobile Computer User’s Manual 79
9 If you choose TLS:
a Load a user and root certificate on your 70 Series. For help, see
“Loading a Certificate” on page 88.
b Enter a User Name and Subject Name.
c For Validate Server Certificate, choose Yes.
d (Optional) To increase your level of security, enter a Server 1
Common name and a Server 2 Common name.
Configuring WPA or WPA2 with Funk Security
Use the following procedure to configure WPA or WPA2 with Funk
security.
1 Make sure the communications and radio parameters on your 70
Series are configured.
2 Make sure Funk is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security.
5 Select the profile you want to configure.
6 For Association, choose WPA or WPA2.
7 For 8021x, choose None.
8 For Pre-Shared Key, enter the pre-shared key or passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the 70 Series internally converts it to
a pre-shared key. This value must match the passphrase on the
authenticator.
9 Save your settings.
Note: The correct date must be set on your 70 Series when you enable
Validate Server Certificate.