User's Manual

Chapter 6 — Configuring the Computer
66 70 Series Mobile Computer User’s Manual
To save a parameter setting:
• Tap OK.
To exit Intermec Settings:
• Tap Menu > Exit or OK.
Configuring ProfileSettings With Intermec Settings
A profile is a set of predefined values that you can easily apply to the
computer to ensure optimal performance in a specific scenario. The
end user does not need to figure out the “right” settings because we
have already done that work for you. ProfileSettings is available from
the Start menu so you can make it available to the end user for easy
configuration.
Use Intermec Settings to determine the profiles you want the end user
to see in the ProfileSettings application.
To configure the profile information an end user can access:
1) Go to Device Settings > Profiles.
2) Select Camera, Power, or Scanning.
3) From the Camera, Power, or Scanning submenu, check or clear the
Display check box for the settings you want to have available to the
end user.
4) Click OK to save your selection.
Restoring Default Settings
You can easily restore a menu to its default settings or all of the
Intermec Settings parameters to their default settings if necessary.
To restore menu defaults:
1) Navigate to the menu you want to restore to defaults.
2) Tap Menu > Restore Menu Defaults.
3) When prompted, tap Yes to restore the menu default settings.
4) If prompted to refresh the computer, tap Yes.