User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Chapter 2 - Understanding the User Interface and Intermec Applications
- Chapter 3 - Using the Phone
- Chapter 4 - Using the Camera
- Chapter 5 - Using GPS
- Chapter 6 - Configuring the Computer
- How to Configure the Computer
- Using Intermec Settings on the Computer
- Using Intermec Settings Remotely With SmartSystems Foundation
- About Network Communications
- About Wireless Security
- Chapter 7 - Managing the Computer
- Chapter 8 - Troubleshooting and Maintaining the Computer
- Appendix A - Specifications and Default Settings
- Physical and Environmental Specifications
- CN70 Physical Dimensions
- CN70e Physical Dimensions
- CK70 Physical Dimensions
- CK71 Physical Dimensions
- Environmental Specifications
- Power and Electrical Specifications
- Operating System
- Hardware
- Back Accessory Interface Pin-outs
- Touch Screen Specifications
- Standard Communications
- Wireless LAN
- Regulatory Approvals
- Bar Code Symbologies
- Imager Reading Distances
- Default Configuration
- Physical and Environmental Specifications
Chapter 1 — Using the Computer
70 Series Mobile Computer User’s Manual 25
3 Point the imager window at the bar code label, and hold the
computer steady a few inches from the label.
4 Press the Scan button. The laser pointer and illumination beam or
frame appear.
Scanning With the EA30 Imager
5 Use the laser pointer as a guide and aim toward the middle of the
bar code. Make sure that the illumination beam or frame covers the
bar code you are trying to decode.
When the computer successfully reads a bar code label, you hear a
high beep, and the Good Read LED turns on briefly.
6 Release the Scan button.
Custom In conditions that require customized
settings. For complete information about
these settings, commands, and
parameters, see the
Intermec Settings Command Reference
Manual.
Predefined Mode For Scanning