User's Manual
Table Of Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Chapter 2 - Understanding the User Interface and Intermec Applications
- Chapter 3 - Using the Phone
- Chapter 4 - Using the Camera
- Chapter 5 - Using GPS
- Chapter 6 - Configuring the Computer
- How to Configure the Computer
- Using Intermec Settings on the Computer
- Using Intermec Settings Remotely With SmartSystems Foundation
- About Network Communications
- About Wireless Security
- Chapter 7 - Managing the Computer
- Chapter 8 - Troubleshooting and Maintaining the Computer
- Appendix A - Specifications and Default Settings
- Physical and Environmental Specifications
- CN70 Physical Dimensions
- CN70e Physical Dimensions
- CK70 Physical Dimensions
- CK71 Physical Dimensions
- Environmental Specifications
- Power and Electrical Specifications
- Operating System
- Hardware
- Back Accessory Interface Pin-outs
- Touch Screen Specifications
- Standard Communications
- Wireless LAN
- Regulatory Approvals
- Bar Code Symbologies
- Imager Reading Distances
- Default Configuration
- Physical and Environmental Specifications
Appendix A — Specifications and Default Settings
120 70 Series Mobile Computer User’s Manual
Below are the typical and minimum standard reading distances for the
70 Series computer built with an EA30 imager. Also included are
typical and minimum standard reading distances for the CK71 with an
EV12 or EX25C imager. When correctly mounted, and exit window
reduces reading distances by about 4% for all scan engines.
EA30 Area Imager Minimum Reading Distances
Minimum distances are measured in the dark (0 lux).
Note: Minimum distances depend on the length of the bar code.
cm
PDF417 10 mils
0.5 mm / 20 mils
1 mm / 40 mils
Data Matrix 10 mils
in
0" 28"24"20"16"12"8"4"
070605040302010
EAN/UPC
0.125mm/5 mils
4"
8"
0"
4"
8"
12"
12"
10
0
10
20
20
30
30