User's Manual
Table Of Contents
- Send Feedback
- Before You Begin
- Chapter 1 - About the Computer Features
- About the 70 Series Mobile Computers
- 70 Series Accessories
- About Language Provisioning
- About the Battery
- About the Keypad
- Configure the Screen Backlight
- Configure the Screen Brightness
- Adjust the Volume
- About the Imager
- Use the Imager as a Flashlight
- Read Bar Codes
- Insert a MicroSD Card
- Transfer Files To and From Your PC
- Chapter 2 - About the User Interface and Intermec Applications
- Chapter 3 - Use the Phone
- Chapter 4 - Use the Camera
- Chapter 5 - Use GPS
Chapter 3 — Use the Phone
54 70 Series Mobile Computer User Manual
5 Slide the SIM card into the slot in the card access door.
6 Close the SIM card door and slide it to the right to lock it in place.
7 Close the card access door and replace the two screws.
8 Install the battery. Press down firmly on the bottom of the battery,
and make sure that the battery release tab is fully engaged.
9 Press the Power button. The computer cold boots.
Activate the CDMA Phone
To activate the CDMA radio module in your mobile computer, you
need to contact your wireless carrier and set up an account for each
mobile computer. The following table lists the carriers that Intermec
currently supports. If your carrier is not listed in the table, please
contact Intermec product support to see if it is now supported.
Currently Supported Carriers
Country Carriers
United States Sprint, Verizon