User's Manual
Table Of Contents
- Send Feedback
- Before You Begin
- Chapter 1 - About the Computer Features
- About the 70 Series Mobile Computers
- 70 Series Accessories
- About Language Provisioning
- About the Battery
- About the Keypad
- Configure the Screen Backlight
- Configure the Screen Brightness
- Adjust the Volume
- About the Imager
- Use the Imager as a Flashlight
- Read Bar Codes
- Insert a MicroSD Card
- Transfer Files To and From Your PC
- Chapter 2 - About the User Interface and Intermec Applications
- Chapter 3 - Use the Phone
- Chapter 4 - Use the Camera
- Chapter 5 - Use GPS
70 Series Mobile Computer User Manual iii
Document Change Record
This page records changes to this document. The document was
originally released as Revision 001.
Version
Number
Date Description of Change
005 11/2012 Added information to support firmware version 1.50:
• CloneNGo application
• New camera settings
• SceneEditor application
• EA30 imager extended reading range
004 2/2012 Revised information on ScanNGo bar codes.
003 12/2011 Added information on:
• the flashlight feature.
• the Carrier Selection application.
Revised information on:
• the Intermec Settings menus.
• upgrading the system software and the operating
system.
• GPS procedures.
• ScanNGo bar codes.
002 06/2011 Revised to add information on
non-incendive (NI) versions of the computer,
provisioning the computer, the new ScanDiagnostics
application, and how to use the 70 Series as a USB
mass storage device. Also corrected the cold boot
procedure and removed the compass.