User's Manual
Table Of Contents
- Document Change Record
- Contents
- Before You Begin
- About the Computer Features
- About the 70 Series Mobile Computers
- 70 Series Accessories
- About Language Provisioning
- About the Battery
- About the Keypad
- Configure the Screen Backlight
- Configure the Screen Brightness
- Adjust the Volume
- About the Imager
- Use the Imager as a Flashlight
- Read Bar Codes
- Read an RFID Tag
- Insert a MicroSD Card
- Transfer Files to and from Your PC
- About the User Interface and Intermec Applications
- Use the Phone
- Use the Camera
- Use GPS
- Configure the Computer
- How to Configure the Computer
- Use Intermec Settings on the Computer
- Use Intermec Settings Remotely with SmartSystems
- About Network Communications
- About Wireless Security
- Manage the Computer
- Manage the Computer in Your Network
- Develop and Install Applications
- RFID Applications and the IF2
- Using the RFID Resource Kit
- Creating RFID Applications for the IF2
- Package Your Application
- Choose a Target Location
- Install Applications Using SmartSystems Foundation Console
- Install Applications Using Microsoft ActiveSync
- Install Applications Using a Storage Card
- Launch Applications Automatically
- Update the System Software
- Troubleshoot and Maintain the Computer
- Specifications and Default Settings
- Physical and Environmental Specifications
- CN70 & CN70 RFID Physical Dimensions
- CN70e & CN70e RFID Physical Dimensions
- CK70 & CK70 RFID Physical Dimensions
- CK71 Physical Dimensions
- Environmental Specifications
- Power and Electrical Specifications
- 70 Series Non-Incendive Computer Specifications
- Operating System
- Hardware
- Back Accessory Interface Pin-outs
- Touch Screen Specifications
- Standard Communications
- Wireless LAN
- Regulatory Approvals
- Bar Code Symbologies
- Imager Reading Distances
- EA30 Typical Reading Distances - Extended Reading Range
- EA30 Area Imager Minimum Reading Distances
- EA30 Area Imager Typical Reading Distances
- EV12 Linear Imager Minimum Reading Distances
- EV12 LInear Imager Typical Reading Distances
- EX25 Near-Far Range Imager Minimum Reading Distance
- EX25 Near-Far Range Imager Typical Reading Distance
- Default Configuration
- Physical and Environmental Specifications
- Keypads and Keystrokes
- ScanNGo Wi-Fi Configuration Bar Codes
- Index
DRAFT
Chapter 1 — About the Computer Features
10 70 Series Mobile Computer User Manual
About the Battery
The computers use these rechargeable Lithium-ion battery pack as the
main power source:
• 3.7 V, 4000 mAH (14.8 Wh) battery for the CN70 and CN70e
• 3.7 V, 5200 mAH (19.2 Wh) battery for the CK70 and CK71
Charge the Battery
You need to fully charge the battery before using your computer for the
first time. Use one of the charging accessories listed in the next table to
charge the battery.
70 Series Charging Accessories
Change the Battery
If your battery power is low, you need to either charge the battery in the
computer, or replace it with a charged battery.
1 Save your files and close any open applications.
2 Press the Power button and choose Hibernate from the menu to
suspend the computer.
The battery used in this device may present a fire or chemical burn
hazard if it is mistreated. Do not disassemble it, heat it above
100 °C (212 °F) or incinerate it. Dispose of used batteries
promptly. Keep away from children.
Charging Accessory Charging Time
Snap-on adapters Up to 6 hours
DX1, DX2, or DX4 dock Up to 6 hours
CN70, CN70e, CK70, and CK71 Vehicle Power Adapter Up to 6 hours