User's Manual

Chapter 2 — Create and Use RFID Applications
IP2L Snap-On LF/UHF RFID Reader User Guide 17
ID Report Enables or disables tag ID report ing after a Read,
Write, or Lock command is executed:
• For ISO tags, the tag identi fier corresponds to
TAGID.
• For EPC tags, the identifier corresponds to
EPCID.
This setting is equivalent to the IDREPORT BRI
attribute.
No Tag Report Enables or disables a NOTAG message, which is
sent when no tags are found during execution of a
Read, Write, or Lock command.
This setting is equivalent to the NOTAGRPT BRI
attribute.
Report Timeout Sets the timeout (in ms) for delays in tag reporting
when the RFID reader is in continuous read mode.
Timeout Mode
ID Tries Sets the maximum number of times the reader
executes the identify algorithm before a response
is returned to a Read or Write command.
In practice, this is the number of times a tag ID
attempt is made for the antenna.
This setting is equivalent to the IDTRIES BRI
attribute.
Antenna Tries
Read Tries Sets the maximum number of times the read
algorithm is executed before a response is
returned to a Read command.
In practice, this is the number of times an
identified tag is read until the Read is successful.
This setting is equivalent to the RDTRIES BRI
attribute.
Write Tries Sets the maximum number of times the read
algorithm is executed before a response is
returned to a Write command.
In practice, this is the number of times an
identified tag is read until the Write is successful.
This setting is equivalent to the WRTIES BRI
attribute.
RFID Module Settings Descriptions (continued)
Setting Description
DRAFT