User's Manual
Table Of Contents
- Contents
- Before You Begin v
- About the IP2L Snap-On LF/UHF RFID Reader 2
- What You Need 3
- Connect and Enable the RFID Reader 4
- Remove the IP2L 6
- Charge the Computer Battery 7
- About the Status LEDs 8
- RFID Tag Read Positions 9
- Read and Write to RFID Tags 12
- RFID Applications and the IP2L 14
- Create Applications for the IP2L 14
- Configure the RFID Service Settings 15
- Configure the BRI Server Settings 15
- Configure the RFID Module Settings 16
- Call Product Support 22
- Troubleshoot the IP2L 23
- Physical Specifications 26
- RFID Specifications 26
- Before You Begin
- About the IP2L Snap-On LF/UHF RFID Reader
- What You Need
- Connect and Enable the RFID Reader
- Remove the IP2L
- Charge the Computer Battery
- About the Status LEDs
- RFID Tag Read Positions
- Read and Write to RFID Tags
- RFID Applications and the IP2L
- Create Applications for the IP2L
- Configure the RFID Service Settings
- Configure the BRI Server Settings
- Configure the RFID Module Settings
- Call Product Support
- Troubleshoot the IP2L
- Physical Specifications
- RFID Specifications
Chapter 1 — About the IP2L Features
12 IP2L Snap-On LF/UHF RFID Reader User Guide
Read and Write to RFID Tags
Use this section to learn how to read or write to RFID tags. Before you
start to read and write to RFID tags:
• connect the IP2L to the computer.
• enable the IP2L
1 Open an RFID application.
2 Press the Scan button on the computer. The Notification LED
turns on and the computer scans for RFID tags in the area.
When the computer successfully or writes to an RFID tag, you
hear a high beep, and the Good Read LED turns on briefly.
3 Release the Scan button on the computer to stop reading and
writing to tags.
DRAFT