User's Manual
Table Of Contents
- Contents
- Before You Begin v
- About the IP2L Snap-On LF/UHF RFID Reader 2
- What You Need 3
- Connect and Enable the RFID Reader 4
- Remove the IP2L 6
- Charge the Computer Battery 7
- About the Status LEDs 8
- RFID Tag Read Positions 9
- Read and Write to RFID Tags 12
- RFID Applications and the IP2L 14
- Create Applications for the IP2L 14
- Configure the RFID Service Settings 15
- Configure the BRI Server Settings 15
- Configure the RFID Module Settings 16
- Call Product Support 22
- Troubleshoot the IP2L 23
- Physical Specifications 26
- RFID Specifications 26
- Before You Begin
- About the IP2L Snap-On LF/UHF RFID Reader
- What You Need
- Connect and Enable the RFID Reader
- Remove the IP2L
- Charge the Computer Battery
- About the Status LEDs
- RFID Tag Read Positions
- Read and Write to RFID Tags
- RFID Applications and the IP2L
- Create Applications for the IP2L
- Configure the RFID Service Settings
- Configure the BRI Server Settings
- Configure the RFID Module Settings
- Call Product Support
- Troubleshoot the IP2L
- Physical Specifications
- RFID Specifications
Chapter 1 — About the IP2L Features
8 IP2L Snap-On LF/UHF RFID Reader User Guide
About the Status LEDs
When the IP2L is connected and enabled, the status LEDs turn on,
turn off, or blink to indicate RFID activity on your computer.
Location of the Status LEDs
Status LED Descriptions
Callout LED Color Description
1 Notification Amber The computer is searching for an
RFID tag
2Good
Read
Blinking
green
The computer successfully reads or
writes to a tag.
3Battery
Status
Blinking
red
The computer unsuccesfully writes to
a tag.
Notification LED
Good Read LED
Battery status LED
DRAFT