User's Manual
Table Of Contents
- Contents
- Before You Begin v
- About the IP2L Snap-On LF/UHF RFID Reader 2
- What You Need 3
- Connect and Enable the RFID Reader 4
- Remove the IP2L 6
- Charge the Computer Battery 7
- About the Status LEDs 8
- RFID Tag Read Positions 9
- Read and Write to RFID Tags 12
- RFID Applications and the IP2L 14
- Create Applications for the IP2L 14
- Configure the RFID Service Settings 15
- Configure the BRI Server Settings 15
- Configure the RFID Module Settings 16
- Call Product Support 22
- Troubleshoot the IP2L 23
- Physical Specifications 26
- RFID Specifications 26
- Before You Begin
- About the IP2L Snap-On LF/UHF RFID Reader
- What You Need
- Connect and Enable the RFID Reader
- Remove the IP2L
- Charge the Computer Battery
- About the Status LEDs
- RFID Tag Read Positions
- Read and Write to RFID Tags
- RFID Applications and the IP2L
- Create Applications for the IP2L
- Configure the RFID Service Settings
- Configure the BRI Server Settings
- Configure the RFID Module Settings
- Call Product Support
- Troubleshoot the IP2L
- Physical Specifications
- RFID Specifications
Chapter 1 — About the IP2L Features
4 IP2L Snap-On LF/UHF RFID Reader User Guide
Connect and Enable the RFID Reader
Connect the IP2L and enable the RFID reader before you start reading
and writing to RFID tags.
1 Connect the IP2L to the bottom of your mobile computer. The
IP2L snaps into place.
2 Tap the Start icon > Settings > System > Intermec Settings.
DRAFT