User's Manual
Table Of Contents
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Using the Color Camera
- Using the Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting Vibrate Mode
- Setting Up GPS on Your CN3
Chapter 1 — Using the Computer
CN3 Mobile Computer User’s Manual 13
To disable the beeper
If your CN3 has a built-in phone, tapping Off will disable both the beeper
and the phone. To disable just the beeper, drag the left slider bar to its
bottom position, like in the following illustration.
3 Tap the Volume icon at the top of the screen, tap On, then move the
slider bar to your desired level. If your CN3 comes with a phone,
then be sure to use the left slider bar for the volume for the rear
speaker and the right slider bar for the phone via the front speaker.
•Tap the Volume icon, then drag the slider to the bottom, or tap Off.
Note the change in the Volume icon.
Phone slider barVolume slider bar