User's Manual Part 2

Chapter 5 — Network Support
132 PRELIMINARY - CN3 Mobile Computer User’s Manual
Configuring WPA Security With Funk Security
Use this procedure to set WPA security with Funk security.
1 Make sure you have configured the communications and radio parame-
ters on your CN3 Computer and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with “X” being “1” through “4.”
3 For Association, select “WPA” and press Enter.
4 For 8021x, select “PEAP,” “TLS,” “TTLS,” “LEAP,” or “EAP-FAST”
and press Enter.
If you select “TTLS” or “PEAP:”
a Select User Name, type your user name, then press Enter.
b Select User Password, type a user password, then press Enter.
c For Validate Server Certificate, select “Yes,” then press Enter. Note
that you must have the date on the CN3 Computer set correctly when you
enable Validate Server Certificate.
d You must enter a User Name and Subject Name. You can also enter a
Server 1 Common name or Server 2 Common name if you want to
increase your level of security.
If you select “TLS:”
a Load a user and root certificate on your CN3 Computer. For help, see
“Loading Certificates” on page 128.
b For Validate Server Certificate, select “Yes,” then press Enter. Note
that you must have the date on the CN3 Computer set correctly when you
enable Validate Server Certificate.
c You must enter a User Name and Subject Name. You can also enter a
Server 1 Common name or Server 2 Common name if you want to
increase your level of security.