User's Manual Part 5

Chapter 5 — Network Support
148 CN3 Mobile Computer User’s Manual
The iFTP menu is available the next time you start iConnect.
To manage the state of the FTP server
• Modify these existing registry keys:
HKEY_CURRENT_USER\Software\iConnect2\IConnect\Settings\FtpAutoStart
HKEY_CURRENT_USER\Software\iConnect2\IConnect\Settings\FtpHeartbeat
where 1 = enable and 0 = disable.
Network Interfaces
The default network adapter or radio is dependent on what radios are
installed in your CN3. With the iConnect menu, using the Enable feature,
you can specify “Wireless” or “No Networking” to load onto your CN3
when a cold-boot is performed.
If you had specified a network prior to when a warm-boot is performed on
the CN3, the iConnect application restores your network interfaces to what
they were before the warm-boot was performed.
See the Developer’s Support area of the Intermec web site for the latest
information on network adapters for your CN3.
To access the iConnect menu
• Select Dismiss from the iConnect menu to end the session without
exiting the application.
• Select Exit iConnect to exit the application.
To access the iConnect application after you have exited it
• Perform a warm-boot on the CN3. The iConnect icon then reappears
above the command bar.
No Networking
To disable the networking interface
• Select Enable > No Networking from the iConnect menu.
The Wireless radio tower icon is replaced with one that shows an “X,” a
check mark appears next to the “No Networking” option in the menu, and
the iConnect application disables all other networking interfaces.
Wireless Communications
To enable wireless communications on the CN3
• Select Enable > Wireless from the iConnect menu.
•Tap the iConnect icon (shown to the left) above your command bar.