User's Manual Part 2
Table Of Contents
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Using the Color Camera
- Using the Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting Vibrate Mode
- Setting Up GPS on Your CN3
Chapter 1 — Using the Computer
26 CN3 Mobile Computer User’s Manual
To set your CN3 to vibrate using the Intermec Settings applet
1 Tap Start > Settings > the System tab > the Intermec Settings icon.
2 Tap (+) to expand Device Settings > Beeper > Vibrate, then tap
Vibrate.
3 To disable the vibrate, tap the Beeper option.
To set the CN3 to vibrate using the Sounds & Notifications applet
1 Tap Start > Settings > the Personal tab > the Sounds &
Notifications icon.
2 Tap the Notifications tab, then select from the Event list.
3 Check Vibrate, then tap ok to close.