User's Manual Part 2
Table Of Contents
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Using the Color Camera
- Using the Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting Vibrate Mode
- Setting Up GPS on Your CN3
Chapter 1 — Using the Computer
CN3 Mobile Computer User’s Manual 25
Once the door to the miniSD is opened (for changing, installing, or
removing the SIM or miniSD card); a cold-boot is performed.
To remove the miniSD card
1 Press the power switch to suspend the CN3.
2 Remove the battery pack.
3 Remove the two screws on the miniSD/SIM card slot door.
4 Remove the miniSD card from the CN3.
Setting Vibrate Mode
To set your CN3 to vibrate
•Tap the Volume icon at the top of the screen, then tap Vibrate. If your
CN3 has a built-in phone, this sets both the volume and the phone to
vibrate. Note the icon change.
miniSD/SIM door
miniSD card slot
SIM card slot