User's Manual Part 2
Table Of Contents
- Chapter 3 - Configuring the Computer
- Developing Applications for the Computer
- Packaging Applications for the CN3 Computer
- Installing Applications on the Computer
- Updating the System Software
- Launching Your Application Automatically
- Customizing How Applications Load on the Computer
- Configuring CN3 Parameters
- Configuring the Color Camera
- Configuring the SF51 Scanner
- Using Configuration Parameters
- Chapter 4 - Maintaining the Computer
- Chapter 5 - Network Support
- Index
Chapter 5 — Network Support
CN3 Mobile Computer User’s Manual - PRELIMINARY 145
Tap ok to return to the Security page.
LEAP (Cisco Lightweight EAP)
LEAP is the Cisco Lightweight version of EAP.
Use “LEAP” to configure the use of LEAP as an authentication protocol,
select “Open,” “WPA,” “WPA2,” or “Network EAP” as an association
mode, or assign “Network EAP.” Note that this defaults to the Network EAP.
1 Set 8021x Security as “LEAP,” then choose one of the following:
•Set Association to “Open.”
•Set Association to “WPA.”
•Set Association to “WPA2” and Encryption to either “TKIP” or
“AES.”
•Set Association to “Network EAP” and Encryption to either “WEP”
or “CKIP.”
2 Enter your unique Username to use this protocol.
3 Select Prompt for password to have the user enter this password each
time to access the protocol, or leave Use following password as selected
and enter your unique password to use the protocol without entering a
password each time you use your CN3 Computer.