User's Manual Part 2

Chapter 3 — Configuring the Computer
88 PRELIMINARY - CN3 Mobile Computer User’s Manual
Configuring the SF51 Scanner
The following information pertains to configuring the SF51 Scanner to
work with your CN3 Computer. These instructions assume you have the
EasySet application installed on your desktop or laptop. The EasySet appli-
cation is available from the Intermec Data Capture web site, contact your
Intermec representative for information about this application.
Imager Settings
Depending on what is selected as the scanner model, image settings, decode
security, scanner settings, and virtual wedge are configured from the Inter-
mec Settings applet. See the Intermec Computer Command Reference Man-
ual, available from the Intermec web site at www.intermec.com, for more
information about each enabled option.
Bluetooth is required for the SF51 Scanner. On the CN3 Computer, use
the Bluetooth applet to enable Bluetooth communications before you con-
figure the SF51 Scanner.
Creating an SF51 Connection Label
To initiate a connection from the SF51 Scanner, use your EasySet applica-
tion to create an SF51 connection label with the CN3 Bluetooth address.
The device address is listed in the Bluetooth applet via the Devices tab on
your CN3 Computer.
Select Start > Settings > the Communications tab > the Bluetooth icon,
check Turn on Bluetooth, then click ok to apply this change.
1 On your desktop or laptop, double-click the EasySet icon to activate the
EasySet application if you have not already done so.
2 In the left side of the EasySet application, double-click Data transmis-
sion settings > Bluetooth parameters > connect/disconnect > compose
BT address.