User's Manual Part 1
Table Of Contents
- Legal Information
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your CN3 Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting the Vibrator
- Wireless Network Support
- Accessories for the CN3 Computer
- Physical and Environmental Specifications
- Chapter 2 - Windows Mobile
- Software Builds
- Where to Find Information
- Basic Usage
- Microsoft ActiveSync
- Microsoft Pocket Outlook
- Calendar: Scheduling Appointments and Meetings
- Synchronizing Calendar
- Why Use Categories in the Calendar?
- What’s an All Day Event?
- What’s a Recurrence Pattern?
- Viewing Appointments
- Creating or Changing an Appointment
- Creating an All-Day Event
- Setting a Reminder for an Appointment
- Adding a Note to an Appointment
- Making an Appointment Recurring
- Assigning an Appointment to a Category
- Sending a Meeting Request
- Finding an Appointment
- Deleting an Appointment
- Changing Calendar Options
- Contacts: Tracking Friends and Colleagues
- Tasks: Keeping a To Do List
- Notes: Capturing Thoughts and Ideas
- Messaging: Sending and Receiving E-mail Messages
- Calendar: Scheduling Appointments and Meetings
- Companion Programs
- Internet Explorer Mobile
Chapter 1 — Using the Computer
18 PRELIMINARY - CN3 Mobile Computer User’s Manual
Wireless Network Support
Radios are installed at the factory and cannot be installed by a user. The
CN3 Computer must be serviced to install or replace radios. Contact your
Intermec representative for more information. See Chapter 5, “Network
Support” for information about supported radios.
Accessories for the CN3 Computer
These are a few of the accessories available for your CN3 Computer. Con-
tact your local Intermec representative about ordering these and other
accessories that may be available.
Quad Battery Charger
Use the Quad Battery Charger to charge up to four CN3 battery packs.
Charge-Only Multidock
Use the Charge-Only Multidock to hold up to four CN3 Computers with
batteries installed, charge batteries, and provide power to CN3 Computers.
Ethernet Multidock
Use the Ethernet Multidock to hold up to four CN3 Computers with bat-
teries installed. The multidock charges the batteries, provides power to the
CN3 Computers, and provides one Ethernet connector.
Single Dock
Use the Single Dock to hold a CN3 Computer with its battery installed,
charge a spare battery pack, charge the main battery, and provide power to
the CN3 Computer. The dock has USB host and client connectors, a mod-
ule to convert the USB host to Ethernet, and a module to convert the USB
host to modem plug over the USB host connector.
Belt
Use this item to carry your CN3 Computer if it has either a 1D linear
imager or a 2D imager, and also accommodates a handle. This supports
either right- or left-handed use.
Note: Changes or modifications not expressly approved by Intermec could
void the user's authority to operate the equipment.