User's Manual Part 1
Table Of Contents
- Legal Information
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your CN3 Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting the Vibrator
- Wireless Network Support
- Accessories for the CN3 Computer
- Physical and Environmental Specifications
- Chapter 2 - Windows Mobile
- Software Builds
- Where to Find Information
- Basic Usage
- Microsoft ActiveSync
- Microsoft Pocket Outlook
- Calendar: Scheduling Appointments and Meetings
- Synchronizing Calendar
- Why Use Categories in the Calendar?
- What’s an All Day Event?
- What’s a Recurrence Pattern?
- Viewing Appointments
- Creating or Changing an Appointment
- Creating an All-Day Event
- Setting a Reminder for an Appointment
- Adding a Note to an Appointment
- Making an Appointment Recurring
- Assigning an Appointment to a Category
- Sending a Meeting Request
- Finding an Appointment
- Deleting an Appointment
- Changing Calendar Options
- Contacts: Tracking Friends and Colleagues
- Tasks: Keeping a To Do List
- Notes: Capturing Thoughts and Ideas
- Messaging: Sending and Receiving E-mail Messages
- Calendar: Scheduling Appointments and Meetings
- Companion Programs
- Internet Explorer Mobile
Chapter 1 — Using the Computer
16 PRELIMINARY - CN3 Mobile Computer User’s Manual
Using the Storage Card
You can use a miniature Secure Digital (mini-SD) card to increase file stor-
age and install software. The mini-SD card slot is located under a door that
is beneath the battery pack. Remove the two screws holding the door to
reach the mini-SD card.
To Insert the Mini-SD Card
1 Press the power switch to suspend the CN3 Computer, then remove the
battery pack from the back of the CN3 Computer.
2 Remove the two screws on the miniSD/SIM card slot door. Note the
screws to this door are to be torqued to 1.5 in-lbs.
3 Gently lift the door to the card slot, then with the metal contacts facing
down, insert the mini-SD card into the card slot connector until the card
lifts up from the floor of the card slot.
4 Press the miniSD/SIM card slot door down, insert the two screws, rein-
sert the battery pack, then press the power switch.
Once the door to the mini-SD is opened (for changing, installing, or
removing the SIM or mini-SD card); a cold-boot is performed.
To Remove the Mini-SD Card
Press the power switch to suspend the CN3 Computer. Remove the battery
pack, then the two screws on the miniSD/SIM card slot door. Remove the
mini-SD card from the CN3 Computer.
Note: MultiMediaCards (MMCs) and CompactFlash (CF) storage cards
are not supported in the CN3 Computer.
Warning: You can corrupt your mini-SD card if you do not follow
these installation and removal procedures exactly. Before installing a
mini-SD card, inspect the gasket on the door for any damage or wear,
and replace the door if any damage or wear is found
Note: The CN3 Computer will reset if the miniSD/SIM door is opened.
The screws to this door must be in place to ensure normal operation.
mini-SD/SIM door
mini-SD card slot
SIM card slot