User's Manual Part 3

Chapter 5 — Network Support
CN3 Mobile Computer User’s Manual - PRELIMINARY 135
If you select “LEAP” or “EAP-FAST:”
a Select User Name, type your user name, then press Enter.
b Select User Password, type a user password, then press Enter.
7 Exit the Intermec Settings applet.
Using Static WEP Security
The CN3 Computer uses the Wired Equivalent Privacy (WEP) protocol to
add security to your wireless network based on the 802.11b/g standard. To
use WEP security, you need an access point with an 802.11b/g radio.
Configuring Static WEP Security With Funk Security
Use this procedure to set Static WEP security with Funk security.
1 Make sure you have configured the communications and radio parame-
ters on your CN3 Computer and that Funk is your security choice.
2 Open Intermec Settings. Tap (+) to expand Communications > 802.11
Radio > Funk Security > Profile X with “X” being “1” through “4.”.
3 For Association, select “Open” and press Enter.
4 For Encryption, select “WEP” and press Enter.
5 For 8021x, select “None” and press Enter.
7 For Transmit key, select which WEP key to use for encryption of trans-
mitted data.
8 Define a value for each key, up to four. Enter an ASCII key or a hex key
either 5 or 13 bytes long based on the radio capability. Set a 5-byte value
for 64-bit WEP or a 13-byte value for 128-bit WEP. Precede hex keys
with 0x and make sure the keys use 5 or 13 hex pairs.
9 Exit the Intermec Settings applet.
Using the Profile Wizard
To start 802.11b/g communications on the CN3 Computer, tap Start >
Settings > the System tab > the Wireless Network icon to access the Pro-
file Wizard for the 802.11b/g radio module.