User's Manual Part 3

Chapter 5 — Network Support
CN3 Mobile Computer User’s Manual - PRELIMINARY 101
Bluetooth
The CN3 Computer retains the Bluetooth state when clean-boots are per-
formed, for example:
• If Bluetooth is enabled, and a clean-boot was performed, the CN3 Com-
puter boots up with the Bluetooth state enabled and Bluetooth virtual
COM ports (such as printing) registered. Reactivate the connections
manually as the system does not do them.
• If Bluetooth is disabled, and a clean-boot was performed, the CN3 Com-
puter boots up with Bluetooth disabled.
Mode
To turn on Bluetooth, select Start > Settings > the Connections tab > the
Bluetooth icon > the Mode tab. Check Turn on Bluetooth, check Make
this device visible to other devices, then click ok.
Devices
Use this tab to scan for other Bluetooth devices.
1 Tap Add new device... to discover (or scan) remote Bluetooth devices.
Bluetooth is not started by default after a clean-boot is performed. To run
Bluetooth, tap Start > Settings > the Connections tab > the Bluetooth
icon.