User's Manual Part 1
Table Of Contents
- Legal Information
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your CN3 Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting the Vibrator
- Wireless Network Support
- Accessories for the CN3 Computer
- Physical and Environmental Specifications
Chapter 1 — Using the Computer
CN3 Mobile Computer User’s Manual - PRELIMINARY 17
Setting the Vibrator
To set your CN3 Computer to vibrate, tap the Volume icon at the top of
the screen, then tap Vibrate. If your CN3 Computer has a built-in phone,
this sets both the volume and the phone to vibrate. Note the icon change.
You can also set the vibrate using the Intermec Settings applet. Tap
Start > Settings > the System tab > the Intermec Settings icon, then tap
(+) to expand Device Settings > Beeper > Vibrate, then tap Vibrate. To
disable the vibrate, tap the Beeper option.
Or use the Sounds & Notifications applet to set the vibrator. Tap Start
> Settings > the Personal tab > the Sounds & Notifications icon, then
tap the Notifications tab. Select the event from the Event drop-down
list, check Vibrate, then tap ok to close.