User's Manual Part 1
Table Of Contents
- Legal Information
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your CN3 Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting the Vibrator
- Wireless Network Support
- Accessories for the CN3 Computer
- Physical and Environmental Specifications
Chapter 1 — Using the Computer
14 PRELIMINARY - CN3 Mobile Computer User’s Manual
Using the Speakers
The high-volume speaker on the back and the top of the CN3 Computer,
is capable of variable volume levels. This speaker is capable of reproducing
voice and WAV files, and is used primarily to convey status tones. There is
a separate volume control in the toolbar at the top of the display. You can
also control the volume using the Intermec Settings applet. Information on
this control and applet are on the next page.
The front speaker is a full-voice range speaker of cell-phone quality with a
separate volume control. See the following paragraph for information about
this volume control.
Warning: Do not place the speaker next to your ear when the speaker
volume is set to “Loud” (maximum), or you may damage your hearing.
High-volume speaker on center, back
Front Speaker