User's Manual Part 1
Table Of Contents
- Legal Information
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Introducing the CN3 Mobile Computer
- Learning Software Build Versions
- Resetting Your CN3 Computer
- Scanning Bar Codes
- Using the Batteries
- Adjusting the Beeper
- Intermec Settings Applet
- Using the Keypad
- Using the Screen
- Software Tools
- Using the Speakers
- Using the Status LEDs
- Using the Storage Card
- Setting the Vibrator
- Wireless Network Support
- Accessories for the CN3 Computer
- Physical and Environmental Specifications
Chapter 1 — Using the Computer
10 PRELIMINARY - CN3 Mobile Computer User’s Manual
Disabling the Beeper
If your CN3 Computer has a built-in phone, tapping Off will disable both
the beeper and the phone. To disable just the beeper, drag the left slider bar
to its bottom position, like in the following illustration.
Intermec Settings Applet
Use the Intermec Settings applet to gather, view, and update device config-
uration settings. Information about the settings you can configure with the
Intermec Settings applet is in the Intermec Computer Command Reference
Manual (P/N: 073529) available online at www.intermec.com.
3 Tap the Volume icon at the top of the screen, tap On, then move the
slider bar to your desired level. If your CN3 Computer comes with a
phone, then be sure to use the left slider bar for the volume and the
right slider bar for the phone.
To disable the beeper, tap the Volume icon, then drag the left slider to the
bottom, or tap Off. Note the change in the Vo l u me icon.
Phone slider barVolume slider bar