User's Manual
Table Of Contents
- Contents
- Before You Begin
- Chapter 1 - Using the Computer
- Chapter 2 - Connecting and Configuring the CN50
- Chapter 3 - Developing and Installing Applications
- Chapter 4 - Troubleshooting andMaintaining the CN50
- Appendix A - Specifications
- Appendix B - Default Settings
- Appendix C - Keypads and Keystrokes
- Appendix D - Imager Configuration Bar Codes
Appendix D - Imager Configuration Bar Codes
80 CN50 Mobile Computer User’s Manual
Imager Configuration Bar Codes
Use the following bar codes to quickly configure the CN50 imager.
These bar codes allow you to enable or disable symbologies, reset to
factory defaults, and set predefined imager modes.
If you need to create a bar code for a specific setup, please download a
free copy of EasySet from the CN50 page on the Intemec web site at
www.intermec.com.
Basic Configuration Bar Codes
Command Bar Code
Disable all symbologies
Reset to Factory Defaults
Postamble with Carriage Return and Line Feed
Imager Predefined Modes
Command Bar Code
1D codes only
Standard 1D and 2D codes